During production of IGU, both mill finish and colored aluminum spacer bar should use the correspond accessories. Standard Aluminum spacer bar should use Plastic corner key to connect four corners; while Bendable Aluminum spacer bar should use Steel Straight Connectors to connect two ends. Leftover spacer bars during operation can also be fully used with steel straight connectors.
The GLASSMATECH series by GLASSMAT is a modern, warm edge hybrid spacer consisting of hard plastic and a fine stainless steel structure.
Its particular construction gives the spacer exceptionally good bending capabilities, high frame stability and U-values at the lowest end of scale. The stainless steel design reduced energy losses due to its lower thermal conductivity.
GLASSMATTECH is permanently UV resistant. Depending on the design of the perforation, they are suitable for the filling of the frames with molecular sieve
Environmental protection, non-toxic and corrosion-resistant.
Strong chemical stability with better thermal insulation, sound absorption and noise reduction effect.